Grizzly G8621 instruction manual Spindles

Page 14

Spindle

The Model G8621 comes with three interchange- able spindles like those in Figure 5. The spindles must be inserted correctly and remain stable in order to produce quality work. When installing and changing spindles, make sure the spindle seats snugly and that there is enough drawbar threaded into the bottom of the spindle to safely secure it in place. To install a spindle:

1.You should not have your machine connect- ed to a power source at this time. If you do, UNPLUG it before you begin.

Figure 5. Spindles.

2.Thread the drawbar approximately 10-15 turns into the bottom of the spindle. The drawbar has two threaded ends. One of them will remain exposed.

3.Drop the spindle/drawbar into the spindle cartridge at the top of the table. Line up the keyway on the spindle with the locating pin at the top of the spindle cartridge. You will feel the spindle seat itself. See Figure 6.

-12-

Align

These

Parts

Figure 6. Installing spindle into the cartridge.

4.Thread the drawbar nut, tapered side up, onto the bottom of the drawbar, as illustrated in Figure 7.

Figure 7. Drawbar nut on spindle.

5.Place the spindle wrench on top of the spin- dle, so it fits over the head of the spindle. Place a 15mm wrench on the drawbar nut.

6.Hold the spindle in place and tighten the drawbar nut. DO NOT use excessive force.

G8621 Heavy-Duty Sliding Table Shaper

Page 13 Page 15
Image 14
Page 13 Page 15
Contents HEAVY-DUTY Sliding Table Shaper Page Table Of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Shapers Circuit Requirements 220V Operation GroundingExtension Cords Wiring General Information CommentaryUnpacking Hardware Figure Miter Gauge Kit Hardware and QtyModel G8621 Hardware and Qty Clean Up Site ConsiderationsAssembly Beginning Assembly HandwheelSpindle SpindlesHandles Guard Fence Assembly Adjustment handle G8621 Heavy-Duty Sliding Table ShaperAttach wooden fence assembly Guard CoverHold-Downs Miter Assembly Page Adjustments Pulleys & V-BeltBelt Tension Speed Changes Fence Adjustment Aligning The Fences Table Inserts Setting Miter Gauge Test Run Operations RotationCutter Installation Table Lock Tightening spindle nutsSpindle Height Straight Shaping Location of spindle lockSee Figure Rub collar installed below cutter Rub CollarsPattern Work Freehand Shaping Miter gauge set to Fences opened for clarityShaper Accessories Locking down the miter clampLubrication MaintenanceGeneral BeltG8621 Shaper Closure Machine Data Sheet G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper PSS23 Ratchet Lock Handle Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC Page #ALL 4ODAYD&ORO
Top Page Image Contents