Grizzly G8621 instruction manual Spindle Height Straight Shaping, Location of spindle lock

Page 27

Spindle Height

Straight Shaping

 

 

 

 

 

 

To adjust the cutter height:

1.Loosen the spindle lock shown in Figure 33.

2.Move the spindle up or down with the hand- wheel until the desired position is obtained.

3.Lock the spindle into position.

Figure 33. Location of spindle lock.

NOTICE

The lock knob keeps the spindle in a fixed position during shaper operation. Do not over-tighten the lock knob. A snug fit is all that is needed to keep the spindle from moving during shaper operation.

Disconnect power to the machine when perform- ing any adjustments or maintenance. Failure to do this may result in seri- ous personal injury.

G8621 Heavy-Duty Sliding Table Shaper

Read the entire manual before making any cuts with your shaper. Serious personal injury may result if safety or operational information is not understood or fol- lowed.

The fence assembly is a two-piece, independent- ly adjustable system. When removing material from the whole face of your workpiece, the out- feed fence can be adjusted to provide support for the workpiece as it passes over the cutter. The outfeed fence can also be set in-line for par- tial face removal.

If removing material from the whole face, observe the following steps:

1.Loosen the locking handles shown in Figure 34 that hold the fences in place.

Figure 34. Location of fence locking handles.

2.Adjust the infeed fence by turning the adjust- ment knobs until the workpiece contacts the cutter in the desired location.

3.Lock the infeed fence in position with the locking handle. Use a test piece to determine the best setting.

-25-

Page 26 Page 28
Image 27
Page 26 Page 28
Contents HEAVY-DUTY Sliding Table Shaper Page Table Of Contents Safety Instructions For Power Tools SafetyLength AMP Rating Additional Safety Instructions For Shapers 220V Operation Grounding Circuit RequirementsExtension Cords Wiring Commentary General InformationHardware Figure Miter Gauge Kit Hardware and Qty UnpackingModel G8621 Hardware and Qty Site Considerations Clean UpBeginning Assembly Handwheel AssemblySpindles SpindleHandles Adjustment handle G8621 Heavy-Duty Sliding Table Shaper Guard Fence AssemblyGuard Cover Attach wooden fence assemblyHold-Downs Miter Assembly Page Pulleys & V-Belt AdjustmentsBelt Tension Speed Changes Fence Adjustment Aligning The Fences Table Inserts Setting Miter Gauge Test Run Rotation OperationsTightening spindle nuts Cutter Installation Table LockLocation of spindle lock Spindle Height Straight ShapingSee Figure Rub Collars Rub collar installed below cutterPattern Work Miter gauge set to Fences opened for clarity Freehand ShapingLocking down the miter clamp Shaper AccessoriesBelt MaintenanceGeneral LubricationG8621 Shaper Closure Machine Data Sheet G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper G8621 Heavy-Duty Sliding Table Shaper PSS23 Ratchet Lock Handle Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC Page #ALL 4ODAYD&ORO
Top Page Image Contents