Hold-Downs | | Miter Assembly |
| | |
| | |
Hold-downs are used to hold the workpiece flat and snug against table as shown in Figure 18. To assemble the hold-downs:
1.Slide a hold-down plate into each of the cast iron hold-down brackets.
2.Insert the bracket pole into the fence bracket and hold-down bracket.
3.Partially screw the handle into the hold-down brackets.
4.Position the hold-downs according to the size of your workpiece.
5.Tighten the handles to secure the hold- downs.
Figure 18. Hold-down on workpiece.
-16-
The miter gauge for the Model G8621 features a clamp and special fence. The miter gauge assembly can be mounted on either end of the table, depending on the type of desired cut or cut- ting direction. To mount the miter gauge and its fence:
1.Locate the threaded holes on either side of the table.
2.Install the push shaft as shown in Figure 19.
Figure 19. Installing the push shaft.
3.Now, slide the miter gauge down the push shaft as in Figure 20.
Figure 20. Installing the miter gauge. G8621 Heavy-Duty Sliding Table Shaper
