Stand
To begin stand assembly, keep all the stand parts within easy reach. To ease assembly, build the stand upside down on a bench and then place it upright on the floor.
1.Place the stand top upside down on your bench.
2.Attach each of the four legs to the stand top with carriage bolts, washers and nuts pro- vided. Do not over tighten. The legs attach to the outside of the stand top. See Figure 3.
3.Position the two upper stand braces and fin- ish installing the carriage bolts. Do not over tighten.
4.Attach each of the four braces to the stand legs with carriage bolts, washers and nuts provided. Do not over tighten. The braces attach to the inside of the legs. See Figure 3.
Figure 3. Completed stand assembly.
5.Press one 5⁄16"-18 x 1⁄2" hex bolt into each rubber foot. Use the washers and nuts sup- plied to attach a rubber foot onto each of the stand legs.
6.Flip the stand right side up and place on the floor. Check to see if the stand is symmetri- cal from two adjacent sides. Adjust if nec- essary and tighten all nuts.
|
|
|
|
|
|
|
|
|
|
|
|
Model G1019Z 14" Bandsaw | |||