Fence Adjustment |
| Test Run |
|
|
|
|
|
|
|
|
|
|
|
|
Fence operation is controlled by the threaded knob located on the front of the fence. The knob, when screwed tight, locks the fence to the front rail. To change the fence position, loosen the knob and slide the fence along the rail. Use a tape measure or ruler to position the fence from the blade.
Speed Changes
Loosen the motor mounting bolts and move the motor accordingly to slacken the
Figure 22. Selecting pulleys for desired blade speed.
Once assembly is complete, adjustments are done to your satisfaction and tools are safely put away, you are ready to test run the machine.
Turn on the power supply at the main panel. Press the switch in the START position. Make sure that your finger is poised on the switch to press in the STOP position, just in case there’s a problem. The bandsaw should run smoothly, with little or no vibration or rubbing noises. Strange or unnatural noises should be investigated and cor- rected before operating the machine further.
If you cannot easily locate the source of an unusual noise or vibration, contact our Service Department for help.
DO NOT attempt to investigate or adjust the machine while it is running. Wait until the machine is turned off, unplugged and all working parts have come to a stop before you do anything! Serious personal injury will result.
|
|
|
|
|
|
|
|
|
| Model G1019Z 14" Bandsaw | |
|
|