Grizzly G5045 instruction manual Positive Stops

Page 18

Positive Stops

The 45° and 90° positive stops ensure that the blade adjustment stops accurately at both ends of its swing. To adjust the positive stops:

1.Disconnect the saw from its power source.

2.Raise the blade to its maximum height.

3.Turn the tilting handwheel as far as it can go clockwise. Place a square against the blade. See Figure 17.

Figure 17. Checking blade angle.

If the square does not contact the blade evenly, you will need to adjust the positive stop. To adjust the positive stop:

1.Loosen the setscrew as shown in Figure 18.

Figure 18. Zero degree positive stop adjustment.

2.Using the handwheel, adjust the blade tilt until the blade contacts the square evenly.

3.Advance the collar until it makes contact with the bracket (C). Re-tighten the setscrew.

4.Tilt the blades 15° and return it to the 0° position. Re-check with your straight edge.

5.Re-adjust if necessary.

Once you are satisfied with the results, repeat the process for the 45° positive stop. To adjust the 45° positive stop:

1.Tilt the blade to its maximum angle.

-16-

G5045 10'' Bench Top Table Saw

Image 18
Contents Bench TOP 10 Table SAW Page Table Of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Table Saws Circuit Requirements 110V Operation GroundingGeneral Information CommentaryClean up Site Considerations Unpacking Piece Inventory Assembly Stand AssemblyBench Mounting Page Handwheels Rip FenceBlade Attachment Blade Guard/Splitter Dust Collection Port Attaching dust collection hose G5045 10 Bench Top Table SawAdjustments Rip Fence Fence TensionMiter Gauge Aligning miter gauge blade slot G5045 10 Bench Top Table SawPositive Stops Table Parallelism CheckFour hex head screws allow Blade adjustment Kickback Causes OperationsTest Run Blade SelectionPage RippingCrosscutting Cross-cutting lumber G5045 10 Bench Top Table SawTable Inserts Safety AccessoriesPushsticks Push PaddlesMaintenance General Unpainted SurfacesLubrication Closure Machine Data Sheet G5045 10 Bench Top Table Saw G5045 10 Bench Top Table Saw Stand LEG Base Saddle G5045 10 Bench Top Table Saw G5045 10 Bench Top Table Saw Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC