Grizzly G5045 instruction manual Table Parallelism, Check

Page 19

2.Place the 45° angle of your square against the blade. If the blade and square are not contacting evenly, Loosen the pointer as shown in Figure 19.

Table Parallelism

The G5045 table is factory-aligned. In the unlike- ly event furthere adjustment is needed, a quick inspection checks table parallelism:

1.Place your miter gauge (set at 90°) in its slot, even with the front of the blade. Place a square between it and the side of the blade. See Figure 21.

2. Choose a tooth on the blade. close to the gauge. Mark the tooth with a felt tip pen. Bring marked tooth 1⁄2" above the table top. Set square to touch the marked tooth.

Figure 19. 45° check.

Figure 20. 45 degree stop collar.

3.Adjust the blade angle until the blade con- tacts the square evenly.

4.Advance the collar until it makes contact with the bracket . Figure 20.

5.Line up and fasen the pointer.

6.Reduce the blade tilt angle, then return it to the 45° position. Re-check with your square.

7.Re-adjust, if necessary.

Figure 21. Testing for table parallelism.

3.Slide the miter gauge toward the back of the saw until the square is at the trailing end of the blade. Keep square in place.

4.Turn the blade so marked tooth is 1⁄2" above the table at the back end of the blade. The square should touch the marked tooth.

 

 

 

 

 

 

 

 

G5045 10'' Bench

 

-17-

 

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Bench TOP 10 Table SAW Page Table Of Contents Safety Instructions For Power Tools SafetyLength AMP Rating Additional Safety Instructions For Table Saws 110V Operation Grounding Circuit RequirementsCommentary General InformationClean up Site Considerations Unpacking Piece Inventory Stand Assembly AssemblyBench Mounting Page Rip Fence HandwheelsBlade Attachment Blade Guard/Splitter Attaching dust collection hose G5045 10 Bench Top Table Saw Dust Collection PortRip Fence Fence Tension AdjustmentsAligning miter gauge blade slot G5045 10 Bench Top Table Saw Miter GaugePositive Stops Check Table ParallelismFour hex head screws allow Blade adjustment Blade Selection OperationsTest Run Kickback CausesPage Cross-cutting lumber G5045 10 Bench Top Table Saw RippingCrosscuttingPush Paddles Safety AccessoriesPushsticks Table InsertsGeneral Unpainted Surfaces MaintenanceLubrication Closure Machine Data Sheet G5045 10 Bench Top Table Saw G5045 10 Bench Top Table Saw Stand LEG Base Saddle G5045 10 Bench Top Table Saw G5045 10 Bench Top Table Saw Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC
Top Page Image Contents