23 | Turbine Installation |
|
|
|
|
Operation
Personal Injury and Property Damage Hazard
Do not touch revolving turbine blades or insert objects, including sticks and screwdrivers, into revolving turbine blades. Failure to follow this may result in death, personal injury or property damage.
PROFESSIONAL INSTALLATION A certified and trained electrician must install and commission this turbine using the National Electric Code (NEC) (or, if in Canada, the Canadian Electric Code (CEC)) and in compliance to the local permitting and zoning codes.
Follow the electrical connections and commissioning procedures in the SMARTBOX™ Controller Manual for the wind turbine start up, operations, and maintenance. The label below is provided to indicate the location of the AC POWER disconnect switch. Please cut out and place near the SMARTBOX™ Controller where an electrician and service personnel can easily see it.
ATTENTION
To Disable Wind Turbine
Disconnect AC Power
Note: AC Power Disconnect Box is located at:
Disconnect & Lock - Out AC Power per NFPA 70E and OSHA Requirements
before servicing and/or maintance.
Windtronics, Inc
621 Sprucewood Avenue
Windsor, ON N9C0B3
Canada
There are no parts in the HONEYWELL™ Wind Turbine that require lubrication or scheduled maintenance. Please follow the manufacturer of the battery for its installation, operation and maintenance. Please contact WindTronics Service with any questions:
The SMARTBOX™ Controller has built in automatic software fail safe procedures that serve as automatic safety turbine shut down modes. However the AC Power MUST be disconnected at the Disconnect AC Power Box as noted in the above label. Furthermore, the
The HONEYWELL™ Wind Turbine is grounded to meet lightning surges. If noise or vibration is detected and if the turbine’s blades rotate very slowly under extremely windy conditions turn turbine off and please contact WindTronics Service at:
HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev 10
