Honeywell WT6500 owner manual Before Installing the Honeywell Wind Turbine

3 Introduction

Before Installing the HONEYWELL™ Wind Turbine:

IMPORTANT

Please take note that the HONEYWELL™ Wind Turbine is a proprietary wind driven electric generator. It is designed to displace annual electric consumption by connecting it to the electric switch board in the proper procedures described in this Owner’s Manual. It may also be used on a stand-alone installation where connecting to a local electric grid is not possible. Its unique and high efficiency design enable it to work in very low wind areas starting at 2 miles per hour (mph) and much higher (to 38 mph). Please follow the Site Selection guidelines for optimal installation.

The HONEYWELL™ Wind Turbine is an electric generator. Only licensed and trained personnel can perform the following installation and maintenance functions:

•Open and work on the SMARTBOX™ Control Equipment.

•Open and work on the Junction Box at the turbine

•Apply any torque to any of the turbine’s fasteners

The installation directions include recommendations of a variety of options. Installation must be approved and certified by your local Professional Engineer (PE) and the installer must acquire all the necessary permits from the local authorities prior to installation.

Your installer must use only proper grounding methods as stipulated by the NEC or

CEC if in Canada.

The HONEYWELL™ Wind Turbine is an electric generator. Therefore high voltage is generated within the system. Be sure to only use installers and maintenance professionals to perform work on this turbine.

Failure to complete and mail in the registration card will affect the Warranty.

Failure to use a licensed and trained installer or follow local codes will adversely affect the warranty coverage and possibly void your warranty.

Please contact WindTronics if there is any doubt or concern regarding this electric generator or its installation.

1-877-946-3898

HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev 10