CIRCUIT REQUIREMENTS
110V Operation
These air compressors are wired for 110/120V, single phase operation only. The chart below shows the maximum amperage draw and recom- mended fusing level for each of the machines.
Model | HP | Amperage | |
|
|
|
|
|
| Max | Fuse |
G8694 | 2.0 | 12 | 15 |
|
|
|
|
G8695 | 2.5 | 17 | 20 |
|
|
|
|
G8889 | 2.0 | 12 | 15 |
|
|
|
|
It is generally best to operate a compressor on a dedicated circuit, i.e. a circuit where there are no other electrical appliances plugged in. The fuse requirements above assume the use of a circuit breaker or a
Grounding
In the event of an electrical short, grounding reduces the risk of electric shock by providing a path of least resistance to disperse electric cur- rent. These machines are equipped with power cords having an
This equipment must be grounded. Verify that any existing electrical outlet and circuit you intend to plug into is actually ground- ed. If it is not, it will be necessary to run a separate 12 A.W.G. copper grounding wire from the outlet to a known ground. Under no circumstances should the grounding pin from any
Extension Cords
If you find it necessary to use an extension cord with your compressor, make sure the cord is rated Hard Service (grade S) or better. Refer to the chart in the standard safety instructions to determine the minimum gauge for the extension cord. The extension cord must also contain a ground wire and plug pin. Always repair or replace extension cords when they become worn or damaged.
Figure 1. Grounded plug configuration.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
G8694/G8695/G8889 Air Compressors | ||||||