Grizzly G0464 instruction manual Safety, Mation about proper operation of the equipment

Page 6

SECTION 1: SAFETY

For Your Own Safety Read Instruction Manual

Before Operating This Equipment

The purpose of safety symbols is to attract your attention to possible hazard- ous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, COULD result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, MAY result in minor or moderate injury.

 

It may also be used to alert against unsafe practices.

NOTICE

This symbol is used to alert the user to useful infor-

mation about proper operation of the equipment.

Safety Instructions for Pneumatic Tools

1.READ THROUGH THE ENTIRE MANUAL BEFORE STARTING MACHINERY. Machinery presents serious injury hazards to untrained users.

2.ALWAYS USE ANSI APPROVED

SAFETY GLASSES WHEN OPERATING MACHINERY. Everyday eyeglasses only have impact resistant lenses, they are NOT safety glasses.

3.ALWAYS WEAR AN ANSI APPROVED RESPIRATOR WHEN OPERATING MACHINERY THAT PRODUCES DUST. Wood dust is a carcinogen and can cause cancer and severe respiratory illnesses.

4. ALWAYS USE HEARING PROTECTION WHEN OPERATING MACHINERY. Machinery noise can cause permanent hearing damage.

5.WEAR PROPER APPAREL. DO NOT wear loose clothing, gloves, neckties, rings, or jewelry which may get caught in moving parts. Wear protective hair covering to contain long hair and wear non-slip footwear.

6.NEVER OPERATE MACHINERY WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS OR ALCOHOL. Be mentally alert at all times when running machinery.

-4-

Model G0464/G0465/G0467/G0468/G0470 Air Compressors

Image 6
Contents AIR Compressor Page Table of Contents Introduction Foreword Contact InfoMachine Data Sheet Safety Mation about proper operation of the equipmentModel G0464/G0465/G0467/G0468/G0470 Air Compressors Additional Safety Instructions For Air Compressors Circuit Requirements 110V OperationGrounding Unpacking SET UPAssembly To assemble the air compressorPlacement Operation Safety Starting OperationsTo start the air compressor Line Pressure Regulation To control the air supply to your toolConnecting Tools To connect air tools to your air com- pressorWhen storing your air compressor, fol- low these guidelines StorageMaintenance ScheduleDraining Tank Pressure Safety ValveTo check the pressure safety valve To drain the tankService TroubleshootingSymptom Possible Cause Possible Solution See Changing Oil Check ValveFixing Air Leaks To find air leaksPressure Switch Pressure switch coverG0464 Parts Breakdown G0464 Parts List DescriptionG0465 Parts Breakdown G0465 Parts List G0467 Parts Breakdown G0467 Parts List REF DescriptionG0468 Parts Breakdown G0468 Parts List G0470 Parts Breakdown G0470 Parts List Warranty and Returns Warranty Card Name Street CityStateZip BOX BELLINGHAM, WA