SECTION 2: CIRCUIT
REQUIREMENTS
110V Operation
Serious personal injury could occur if you connect the machine to the power source before you have com- pleted the set up process. DO NOT connect the machine to the power source until instructed to do so.
Amperage Draw
The motors on the air compressors will draw the following amps:
G0464 Motor Draw | ...................... 8 | Amps |
G0465 Motor Draw | ...................... 8 | Amps |
G0467 Motor Draw | ..................14.5 | Amps |
G0468 Motor Draw | ...................... 8 | Amps |
G0470 Motor Draw | 14 | Amps |
Circuit Requirements
Only connect your machine to a cir- cuit that meets the requirements below. Always check to see if the wires and circuit breaker in your circuit are capable of handling the amperage draw from your machine, as well as any other machines that could be operating on the same cir- cuit. If you are unsure, consult a qualified electrician.
Model G0464, G0465, G0468 Minimum
Circuit Requirement | 15 Amp |
Model G0467, G0470 Minimum Circuit | |
Requirement | 20 Amp |
Plug/Receptacle Type
Plug Type ..............NEMA |
Figure 1. Typical type 5-15 plug and
receptacle.
This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a two- pronged outlet! If the plug will not fit the outlet, have the proper outlet installed by a qualified electrician.
Model G0464/G0465/G0467/G0468/G0470 Air Compressors |