Functional Description
Specifications
Working Air | ||
Pressure Range | nail length and wood density) | |
Air Inlet | 1/4” | |
Nail Type | ||
| ||
Fastener Type | Plastic Collated Full Head Nails | |
Magazine | 60 Nails | |
Capacity | ||
| ||
| 3 CFM @ 90 PSI | |
Air Consumption | (Intermittent use) | |
12 CFM at 90 PSI | ||
| (Required for continuous use) | |
Safety Trigger | Single Sequential Actuation |
*The pressure setting must not exceed the job site regulations/restrictions.
Air Supply
To prevent explosion:
Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.
Initial Tool Set Up/
Assembly
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Unpacking
When unpacking, check to make sure item is intact and undamaged. If any parts are missing or broken, call Harbor Freight Tools at the number shown throughout the manual as soon as possible.
•This air tool may be shipped with a protective plug covering the air inlet. Remove this plug before set up.
1.Incorporate an
Note: If an automatic oiler system is not used, add a few drops of Pneumatic Tool Oil to the airline connection be- fore operation. Add a few more drops after each hour of continual use.
2.Attach an air hose to the compres- sor’s air outlet. Connect the air hose to the air inlet of the tool. Other com-
Revised 09i; 09l
SKU 98733 | For technical questions, please call | Page 7 |