store the tool in a clean, dry, safe location out of reach of children.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION: Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the switch to its off position before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise, vibration, or leaking air occurs, have the problem corrected before further use.
TO PREVENT EXPLOSION: Lubricate tool only with specified lubricants. Lubricate air inlet using only pneumatic tool oil. Lubricate the internal mechanism using only white lithium grease. Other lubricants may damage the mechanism and may be highly flammable, causing an explosion.
Cleaning, Maintenance, and
Lubrication
Note: Anytime inspection, maintenance and cleaning are done:
1.Disconnect the Floor Nailer from its air supply.
2.Empty the Magazine (52) and Slide Load Magazine (61) completely.
3.Try to fire the Nailer into a piece of scrap wood or flooring to ensure that it is disconnected and inca- pable of firing any nails/staples.
4.Inspect the air supply screen located in the Adapter (82) before each use. Clean or replace as necessary. Dirt in the air supply is a major cause of pneumatic tool wear. Use a filter in the compressed air system for better performance and longer tool life.
5.Wipe down exterior of the Nailer with a clean cloth before storing.
6.Store in a clean, dry and safe location out of reach of children.
CAUTION! All maintenance, ser- vice or repairs not listed in this manual are only to be attempted by a qualified service technician.
SKU 99640 | For technical questions, please call | Page 12 |