Troubleshooting
Problem |
| Possible Causes |
| Likely Solutions |
Air leaking in Head | 1. | Loose Bolt (3). | 1. | Tighten and recheck. |
Cap (5). | 2. | Lock Ring (11) is cracked or | 2. | Replace Lock Ring. |
|
| worn. |
|
|
Lack of power. | 1. | Tool is too dry. | 1. | Add about 3 drops of pneumatic tool oil into |
Slow to cycle. |
|
|
| the Air Plug (82). |
Low power when | 2. | Air pressure too low. | 2. | Check to make sure regulator on air |
shooting and |
|
|
| compressor is set between 70 PSI and 120 |
returning. |
|
|
| PSI. |
| 3. | Exhaust blocked. | 3. | Clean exhaust channel. |
Not shooting | 1. | Damaged Pusher Spring (51). | 1. | Replace Spring. |
fasteners or | 2. | Wrong size of fasteners. | 2. | Use 1/2” Crown Flooring Staples or |
only intermittent |
|
|
| “L” or “T” Type Flooring Cleats. |
feeding. | 3. | Fixed Magazine (52) or | 3. | Clean Fixed Magazine and Plate. |
| ||||
|
| Plate (45) is dirty. |
|
|
|
|
|
|
|
Fastener is | 1. | Driver channel is worn. | 1. | Replace Plate (45). |
jammed in tool. | 2. | Piston (25) is broken or worn. | 2. | Replace Piston. |
| 3. | Bent fasteners. | 3. | Remove bent fasteners. Replace with 1/2” |
|
|
|
| Crown Flooring Staples or |
|
|
|
| “T” Type Flooring Cleats. |
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect air supply before service.
SKU 99640 | For technical questions, please call | Page 13 |