Page 27
Image 27
•Check all phone cords and connec- tions. Make sure they are plugged in securely.
•Switch out handset or telephone line cords.
•Disconnect any other equipment that may be attached to the phone.
•Make sure TONE/PULSE switch is set correctly.
•Phone may be at the end of a long line of phones (loop). Phone may not be getting enough power from the phone line. It may be necessary to wait for a few seconds after lifting the handset to begin dialing.
•Too many phones or phone devices on the line may effect your phone’s transmission.As a guideline, more than five (5) phones or phone devices may overload the phone line. Disconnect one (1) or two (2) devices to see if that eliminates the problem. If not, contact your local phone com- pany for load guidelines.
•You may not be speaking directly into the transmitter.Always speak directly into the mouth piece in your normal tone of voice.
•Make sure the Ringer OFF/ON setting is set to ON. Increase the volume of the ring if necessary.
•Too many phone or phone devices on a line may cause your phone to not ring. Disconnect one (1) or two (2) of the devices to see if the problem is eliminated. If not, contact your local phone company for load guide lines.
•BOOST must be activated to turn on the additional amplification.
•Press the MODE key to confirm the easy mode state. If the telephone is in EASY mode, these features will not work.Turn off EASY mode (in Setup Menu) if you wish to use these features (see page 12).
26