Parkside PPHSS 730 SE manual Preparing for use / Operation / Maintenance and cleaning

Page 12

Preparing for use / Operation / Maintenance and cleaning

Attaching the guide fence

Setting the pendulum action

The guide fence 19 can be attached on the left or right side of the device (see Fig. A).

Release the two locking screws of the fence guide openings 15 .

Slide the guide fence 19 into the fence guide openings 15 .

Retighten the two locking screws.

Connecting the vacuum sawdust extraction device

Insert the dust extraction spout 7 into the vacuum extraction duct 8 until it engages. Connect a vacuum device approved for the extraction of sawdust and splinters to the dust extraction spout 7 (see Fig. C).

Operation

Setting the cutting angle

Release the clamp screw 11 using the Allen key 20 .

Set the cutting angle 0° / 15° / 30° / 45° (left / right) on the base plate 9 . The embossed marking for each recessed line indicates the cutting angle setting. The housing has a stop pin 21 (see Fig. B) which must engage in the appropriate recessed line.

Tighten the clamp screw 11 using the Allen key 20 .

Setting the speed

 

Set the desired speed using the oscillation speed setting wheel 4 .

If possible always determine the optimum setting beforehand by carrying out a practical test.

You can set the pendulum movement of the saw blade 14 using the pendulum action switch 12 . By having no pendulum action (setting “0”) you can produce fine, clean cut edges. Turn off the pendulum action for thin workpieces.

With the pendulum action activated (settings 1 – 3) you can cut through the workpiece at increasingly quicker rates.

If possible always determine the optimum set- ting beforehand using a practical test.

Switching On / Off

DANGER! Before connecting to the mains plug check that the mains circuit supplies

230 V ~ 50 Hz and is fitted with a 16 A fuse or cut-out in accordance with the regulations!

Switching on:

Push the ON / OFF switch 2 into position “I” and ensure it engages.

Switching off:

Press the rear part of the ON / OFF switch 2 .

Maintenance and cleaning

Maintenance

Replace the saw blade 14 as soon as its teeth become blunt and it starts to produce defective saw cuts.

Cleaning

Carry out that cleaning of the device when you have finished sawing.

GB/IE/CY 11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Pphss 730 SE Page 13 12 10 9 10 mm 260 mm 70 mm 65 mm 30 mm 205 mm 110 mm 150 mm 10 mm 395 mm x 185 mm x 10 mm 395 mm x 120 mm x 10 mm Table of contents Features and equipment IntroductionJigsaw Pphss 730 SE Introduction Proper useWorkplace safety Included itemsTechnical information General safety advice for electrical power tools Electrical safetyPersonal safety Careful handling and use of electrical power toolsSafety advice relating specifically to this device After switching off do not brake the saw bladeDo not work on moistened materials or damp surfaces Original accessories / attachments Information about saw bladesMounting / replacing saw blades Attaching the chip guardPreparing for use / Operation / Maintenance and cleaning Service centre Warranty DisposalAccordance with European Directive Declaration of Conformity / Manufacturer Declaration of Conformity ManufacturerKompernass Gmbh
Top Page Image Contents