INSPECTION, MAINTENANCE, AND CLEANING
1.BEFORE EACH USE, inspect the general condition of the product. Check for misalignment or binding of moving parts, cracked or broken parts and any other condition that may affect its safe operation. Do not use damaged equipment.
2.Remove dirt and debris from the Staple Gun using a clean, soft cloth. Do not use flammable corrosive or abrasive solvents to clean the Staple Gun.
Troubleshooting
Problem | Possible Causes |
| Probable Solutions |
Staple Gun does not | 1. Staples not loaded correctly. | 1. | Verify that staples are loaded into |
staple | 2. Magazine Unit not fully and |
| the Magazine Unit flat and with |
|
| prongs facing upward. | |
| properly inserted into Staple Gun. |
| |
|
|
| |
| 3. Lever not pulled completely up and | 2. Check that Magazine Unit is fully | |
|
| inserted. | |
| then fully pressed down. |
| |
|
|
| |
|
|
|
|
Stapler jams during | 1. Staples jammed in channel. | 1. | Pinch the clip located on the |
operation |
|
| end of the Magazine Unit (2). |
|
|
| Pull out the Magazine Unit (2)- |
|
|
| see Figure 1. |
|
| 2. | Remove jammed staples from |
|
|
| the channel. You may need |
|
|
| to use |
|
|
| included). |
|
| 3. | Make certain that you are using |
|
|
| correct size staples. |
|
| 4. | Close Magazine Unit. |
|
|
|
|
PARTS LIST
Part | Description | Q’ty |
1 | Staple Gun Body | 1 |
|
|
|
2 | Magazine Unit | 1 |
|
|
|
3 | Staple Channel | 1 |
|
|
|
Part | Description | Q’ty |
4 | Force Selection Lever | 1 |
|
|
|
5 | Box of | 2 |
| 5/16” long |
|
|
|
|
SKU 95718 | For technical questions, please call | Page |