Accessories |
| |
We recommend that you buy |
| |
A | ||
all your accessories such as | ||
| ||
nails from the store where you |
| |
bought the tool. Use good quality |
| |
accessories with a |
| |
brand name. Store personnel |
| |
can help and advise (Fig. A). |
| |
Unpacking |
| |
|
Due to modern mass production techniques, it is unlikely that your power tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Assembly
The ALN18V Allnailer® is packed fully assembled.
Installing and removing the battery pack
Make sure your finger is not on
the trigger when removing theB battery pack (Fig. B).
To remove the battery pack, press the tabs on each side of the battery pack and slide the battery pack off the tool (Fig. C & D).
C |
| D |
|
|
|
To insert the battery pack, align the tongue on the pack with the groove in the housing and slide it into the tool. Make sure that it “clicks” into its final position so that it is safely locked in place.
CAUTION. There is no need to use strong force to insert the battery pack. If it does not slide into place easily, it is not being inserted correctly.
Battery charging
IMPORTANT. Before connecting
the battery to the charger (8)E always ensure that the plug is
switched off at the mains.
Slide the battery on to the charger with the rails of the battery pack aligned with the rails of the charger. Slide the battery down until it “clicks” into position
(Fig. E). Switch the plug on at the mains.
The red light on the charger should begin to glow continuously, indicating that the battery pack is receiving a “Fast Charge”.
After approximately one hour, the “Fast Charge” indicator light (red) should go out and the green light should be lit, indicating that the battery pack is fully charged.
Note. It is necessary to depress both of the battery pack release buttons in order to remove the battery pack from the charger.
Depending on room temperature, line voltage, and existing charge level, the initial battery charging may take longer than one hour.
Disconnect the charger from the power source when it is not in use.
To obtain the best life for the battery
Never allow the nailer battery to discharge completely before recharging. The battery should be placed on charge whenever the battery is noticeably running down or the nailer no longer performs a task it previously performed.
Avoid conducting short charges. Make sure that the battery is fully charged every time by allowing the charger to complete its full charging cycle.
10