8. Mount the new saw blade onto
the spindle and against theI inner flange (Fig. H).
9.Replace the outer flange and washer and tighten the blade bolt by turning in an anti- clockwise direction (Fig. I).
10.Ensure that the spindle lock button (15) is released.
11.Before using the saw again, check that the
safety devices ie. Lower blade guard, are in good working order.
IMPORTANT. After replacing the saw blade, make sure that the saw blade runs freely by turning the blade by hand. Check that the directional arrow on the saw blade points clockwise when viewed from the mounting side.
12.Plug the machine into a power socket and run the saw under no load to check that it runs smoothly before using it to cut any material.
Using the water system
CAUTION. Always ensure that the tool is switched off and unplugged from the power supply before making any adjustments.
WARNING. Be sure to always use a tile cutting blade designed specifically for wet tile cutting. When used properly with the water system, wet cutting tile blade will give a consistently smoother cut.
IMPORTANT. NEVER use the water cooling system when cutting timber. It must be removed before use.
J |
| K |
|
|
|
1. Firmly slide the water distribution tube (26) onto the water inlet tube (24). Ensure it is fitted firmly (Fig. J). If you find it difficult to slide the tube on, submerge the end of the tube in hot water then try again. This will assist the tube
in stretching to size. |
| |
L | ||
Note. Before using the water system | ||
| ||
with the tool, always ensure the |
| |
RCD (29) is in good working order. |
| |
2. Insert the water tube plug (28) |
| |
into a hose socket connection |
| |
(Fig. K). |
| |
3. Turn the water on lightly at the |
| |
| ||
M | ||
faucet (Fig. L). |
4.Adjust the amount of water flow by simply adjusting the water cock (25) (Fig. M).
Adjusting the cutting depth
CAUTION. Always ensure
that the tool is switched off andN unplugged from the power supply
before making any adjustments.
1.Ensure that the saw is facing away from you.
2.Loosen the depth locking lever (13) by pushing the lever downwards (Fig. N).
3.Hold the base plate flat against the edge of the work piece and lift the body of the saw until the blade is at the right depth (Fig. O & P). Use the depth of cut indicator (14) to determine the cutting depth.
O |
| P |
|
|
|
12