Clearing Jammed
Nails
A jammed nail must be cleared before using the nailer again.
Framing Nailer
To clear a jammed nail from the dis- charge area:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Pull back and latch the magazine push- er.
3.Remove the nail stick from the maga- zine.
4.Locate the opening in the underside of the nailer safety nose (see Figure 9).
Nose Opening
Figure 9. Nose opening for clearing a
jammed nail.
5.Dislodge the jammed nail with a tool that will fit in the slot on the underside of the nose.
6.Throw the damaged nail away and insert a new nail stick that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!
7.Release the catch lever and slowly let the pusher slide to the front of the magazine.
Brad Nailer
To clear a jammed nail from the dis- charge area:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Depress the magazine latch and pull the magazine cover back until it stops.
3.Remove the nail stick from the maga- zine.
4.Remove the two cap screws and driver guide cover from the nose assembly (see Figure 10).
����������
�����������
Figure 10. Removing guide cover.
5.The jammed nail should now be visible; remove it with needle nose pliers.
6.Re-install the guide cover with the two cap screws removed in Step 4.
7.Throw the damaged nail away and insert a new nail stick that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!
8.Push the magazine cover all the way forward until the magazine latch locks it in place.
Model H8235 |