Grizzly H8235 owner manual To replace a piston for your palm nail- er

8.Apply a thin film of tool oil on the new O-ring and place it on the new piston.

9.Insert the new piston in the cylinder. Make sure that the grooves on the pis- ton shaft line up with those on the guide at the bottom of the cylinder. The new piston should easily slide into the cyl- inder. DO NOT force the piston into the cylinder! If the piston is not easily inserted, double-check the alignment of the piston shaft with the grooves on the guide.

10.After the piston is inserted correctly, close the magazine. Replace the rear cap assembly and secure it with the four cap screws removed in Step 3.

Note: For more assistance, or to install a complete O-ring set, refer to the appropriate breakdown diagram in the back of this manual for component locations.

Palm Nailer

To replace a piston for your palm nail- er:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Using a 19mm wrench, remove the nose piece, depth guide, compression spring, and flat washer.

3.Use the 4mm hex wrench to remove the four cap screws on the nailer cap, then remove the cap.

4.Push the ram pin towards the inside of the nailer—this will push the cylinder free of the housing.

5.Grab the ram pin and pull the piston from the cylinder.

6.Apply a thin film of tool oil on the new O-ring and place it on the new piston.

7.Insert the new piston into the cylinder. The new piston should easily slide into the cylinder. DO NOT force the piston into the cylinder! If the piston is not easily inserted, check the alignment of the piston inside the cylinder.

8.After the piston is inserted correctly, place the cylinder back in the nailer housing. If seated correctly, the cylin- der will snap into place.

9.Push the cylinder collar down into the housing as far as it will go. The horizon- tal air slots on the cylinder sides should be visible.

10.Replace the rear cap and secure it with the four cap screws removed in Step 3.

11.Re-install the flat washer, compression spring, depth guide, and nose piece onto the front of the nailer, then use a 19mm wrench to tighten the nose piece.

Note: For more assistance, or to install a complete O-ring set, refer to the appropriate breakdown diagram in the back of this manual for component locations.

-14- Model H8235 3-Piece Framing/Brad/Palm Nailer Kit