Grizzly H7664 instruction manual Compressed Air System

Compressed Air

System

The Model H7664 is designed to be oper- ated at 60-100 PSI using clean, dry, regu- lated, compressed air. DO NOT exceed the 120 PSI maximum operating pres- sure for your model.

Before using your new nailer/stapler, reg- ulate the air pressure on your air compres- sor to the minimum PSI for your model.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the nailer/ stapler as possible.

This filter/lubricator/regulator unit will protect your tool from damaging water build-up, allow you to adjust and maintain constant air pressure to your tool, and save you the inconvenience of having to manually lubricate your tool every time you use it.

Exceeding the maximum permissible operating pressure may cause the nailer/stapler to explode, blowing metal fragments in all directions. To protect yourself from serious per- sonal injury, DO NOT allow your air compressor to exceed the recom- mended pressure when connected to this nailer/stapler!

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Quick	Quick			Filter
Connector	Connector Oiler
Your				Air
Tool				Compressor
Quick
Coupler		Quick	Regulator
	Air Hose
		Coupler

Figure 2. Typical filter/lubricator/regulator installation order.

-10- H7664 2-in-1 Combination Nailer/Stapler