Grizzly H7664 instruction manual

Page 16

6.Open the nose cover as if to clear a jammed nail/staple.

7.Watch the discharge area and push the top of the piston with your finger. You will see the piston shaft slide down the discharge area.

8.With a long flathead screwdriver or similarly shaped tool, push the piston shaft back inside the nailer/stapler until you can grip the piston head and remove it from the cylinder. (Be care- ful not to scratch the discharge area when pushing the piston shaft with the screwdriver.)

9.Place a new O-ring on the new piston and apply a thin film of the nailer/sta- pler lubricating oil on the O-ring.

10.Insert the new piston in the cylinder. Make sure that the grooves on the pis- ton shaft line up with those on the guide at the bottom of the cylinder. The new piston should easily slide into the cyl- inder. DO NOT force the piston into the cylinder! If the piston is not easily inserted, double-check the alignment of the piston shaft with the grooves on the guide.

11.After the piston is inserted correctly, close the magazine pusher. Replace the rear cap assembly and tighten the 4 cap screws.

12.For more assistance, or to install a complete O-ring set, refer to the appro- priate breakdown diagram in the back of this manual for component loca- tions.

-16-

H7664 2-in-1 Combination Nailer/Stapler

Page 15 Page 17
Image 16
Page 15 Page 17
Contents IN-1 Combination NAILER/STAPLER Page Table of Contents Safety Instructions For Pneumatic Tools SafetyBefore Operating This Equipment Wear Approved Hearing Protection Additional Safety Instructions for Nailers Staplers H7664 2-in-1 Combination Nailer/Stapler Foreword Contact Info IntroductionTool Data UnpackingInventory SET UPModel H7664 Inventory Figure Compressed Air System Safety Yoke Disconnect NAILER/STAPLER from the AIR SupplyOperations LoadingOperating To load your nailer/staplerAdjusting Depth To adjust the depthTo operate your nailer/stapler in single fire mode To operate your nailer/stapler in bump fire modeTo clear a jammed nail or staple from the magazine Disconnect the NAILER/ Stapler from the AIR SupplyTo clear a jammed nail from the dis- charge area Replacing Pistons/O RingsTo replace a piston and O-ring Page Maintenance CleaningLubricatingTroubleshooting Symptom Possible Cause SolutionH7664 Parts Breakdown H7664 Parts List DescriptionWarranty and Returns H7664 2-in-1 Combination Nailer/Stapler Warranty Card Name Street CityStateZip Fold Along Dotted LineGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WA
Top Page Image Contents