Grizzly H7664 Before Operating This Equipment, Safety Instructions For Pneumatic Tools

Page 4

SECTION 1: SAFETY

For Your Own Safety Read Instruction Manual

Before Operating This Equipment

The purpose of safety symbols is to attract your attention to possible hazard- ous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, COULD result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, MAY result in minor or moderate injury.

 

It may also be used to alert against unsafe practices.

NOTICE

This symbol is used to alert the user to useful infor-

mation about proper operation of the equipment.

Safety Instructions For Pneumatic Tools

1.

KEEP ALL SAFETY DEVICES IN

5.

KEEP CHILDREN AND VISITORS

 

PLACE and in working order.

 

AWAY. All children and visitors

2.

REMOVE ADJUSTING KEYS AND

 

should be kept at a safe distance

 

WRENCHES. Form habit of check-

 

from work area.

 

ing to see that keys and adjusting

6.

MAKE WORKSHOP CHILD

 

wrenches are removed from tool

 

PROOF by locking your shop and

 

before operation.

 

shutting off air valves.

3.

KEEP WORK AREA CLEAN.

7.

DO NOT FORCE TOOL. It will do

 

Cluttered areas and benches invite

 

the job better and safer at the rate

 

accidents.

 

for which it was designed.

4.

DO NOT USE IN DANGEROUS

8.

USE THE RIGHT TOOL. Do not

 

ENVIRONMENT. Do not use pneu-

 

force tool or attachment to do a job

 

matic tools in damp or wet loca-

 

for which it was not designed.

 

tions, or where any flammable or

9.

DO NOT USE UNDER THE

 

noxious fumes may exist. Keep

 

INFLUENCE OF DRUGS OR

 

work area well lighted.

 

ALCOHOL.

 

 

 

-4-

 

H7664 2-in-1 Combination Nailer/Stapler

Image 4
Contents IN-1 Combination NAILER/STAPLER Page Table of Contents Safety Instructions For Pneumatic Tools SafetyBefore Operating This Equipment Wear Approved Hearing Protection Additional Safety Instructions for Nailers Staplers H7664 2-in-1 Combination Nailer/Stapler Foreword Contact Info IntroductionTool Data UnpackingInventory SET UPModel H7664 Inventory Figure Compressed Air System Safety Yoke Disconnect NAILER/STAPLER from the AIR SupplyOperations LoadingOperating To load your nailer/staplerAdjusting Depth To adjust the depthTo operate your nailer/stapler in single fire mode To operate your nailer/stapler in bump fire modeTo clear a jammed nail or staple from the magazine Disconnect the NAILER/ Stapler from the AIR SupplyTo clear a jammed nail from the dis- charge area Replacing Pistons/O RingsTo replace a piston and O-ring Page Maintenance CleaningLubricatingTroubleshooting Symptom Possible Cause SolutionH7664 Parts Breakdown H7664 Parts List DescriptionWarranty and Returns H7664 2-in-1 Combination Nailer/Stapler Warranty Card Name Street CityStateZip Fold Along Dotted LineGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WA