Grizzly G6049 instruction manual Operation, Loading Nailer, Single/Bump Fire Mode

Page 7

OPERATION

Loading Nailer

To load your nailer:

1.Disconnect the air supply from the nailer!

2.Load nails at the top of the magazine in the T-slot as shown in Figure 1.

Figure 1. Loading the nailer (side view and end view). Match nail heads with head slot for insertion.

3.Slide the stick of nails all the way down to the nose of the nailer.

4.Pull the magazine pusher all the way back, then let it come forward until it catches on the end of the nail stick.

When replacing nails for your Model G6049, follow these guidelines:

Gauge: 14/15

Length: 114"-212"

Capacity: 100 Nails

Single/Bump Fire Mode

The Model G6049 is equipped with a sin- gle/bump fire trigger.

To select single or bump fire operation:

1.Disconnect the air supply from the nailer!

2.Locate the hex nut that secures the safety yoke mechanism to the trigger housing. See Figure 2.

3.To select Single Fire mode, tighten the hex nut completely.

4.To select Bump Fire mode, unthread the hex nut at least two full turns.

Adjustment

Hex Nut

Figure 2. Single/bump fire adjustment.

-6-

G6049 14/15 Gauge Angle Finish Nailer Kit

Image 7
Contents Model G6049 14/15 Gauge Angle Finish Nailer KITBefore Operating This Equipment SafetySafety Instructions For Pneumatic Tools Basic Nailer Safety Commentary IntroductionCompressed Air System Safety Yoke MechanismOperation Single/Bump Fire ModeLoading Nailer Operating Nailer Adjusting DepthDisconnect the nailer from the air supply Clearing Jammed NailsOiling Nailer Cleaning NailerReplacing Pistons/O-Rings 35A 15A 16A 7A92 G6049 Part BreakdownDescription Problem Cause Action TroubleshootingWarranty and Returns Warranty Card Place Stamp Here