Grizzly H6145 instruction manual Compressed Air System

Compressed Air

System

The Model H6145 is designed to be oper- ated at 70-120 PSI using clean, dry, regu- lated, compressed air. DO NOT exceed the maximum operating pressure for your model.

Before using your new nailer, regulate the air pressure on your air compressor to the minimum PSI for your model.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the nailer as possible.

This filter/lubricator/regulator unit will protect your tool from damaging water build-up, allow you to adjust and maintain constant air pressure to your tool, and save you the inconvenience of having to manually lubricate your tool every time you use it.

Exceeding the maximum permissible operating pressure may cause the nailer to explode, blowing metal frag- ments in all directions. To protect yourself from serious personal injury, DO NOT allow your air compressor to exceed the recommended pressure when connected to this nailer!

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Quick	Quick		Filter
Connector	Connector Oiler
Nailer
Quick
Coupler		Quick Regulator
	Air Hose
		Coupler

Air

Compressor

Figure 2. Filter/Lubricator/Regulator Unit.

-6- H6145 28° Clipped Head Framing Nailer