ASSEMBLY INSTRUCTIONS
THE COMPRESSOR IS SHIPPED WITHOUT OIL IN THE CRANKCASE. ADD OIL AS INDICATED BELOW.
STEP 1 – PUMP LUBRICATION
This air compressor features an oil lubricated pump that requires the use of SAE 30 weight
Adding Compressor Oil:
1.Place air compressor on a flat, level surface.
2.Remove plastic oil fill breather plug (see Fig. 1).
3.Open supplied oil bottle and pour oil into crankcase until the oil level reaches the center of the red circle in the oil level sight glass (see Fig. 2). Be careful not to overfill.
Fig. 1
CAUTION |
CHECK OIL |
LEVEL DAILY! |
OIL LEVEL OK |
REFILL OIL |
IMMEDIATELY |
OIL CAPACITY: 2.7oz (80ml) |
Fig. 2
4.See diagram for determining proper oil fill level using oil fill sight glass (see Fig. 3).
5.Install supplied plastic oil fill breather plug securely into oil fill hole.
Fig. 3
DO NOT OPERATE THE COMPRESSOR WITHOUT LUBRICANT, OR WITH LOW LUBRICATION LEVEL. THE MANUFACTURER IS NOT
RESPONSIBLE FOR DAMAGE CAUSED TO THE COMPRESSOR DUE TO OPERATION WITHOUT PROPER LUBRICATION.
STEP 2 – INSPECTION CHECK
Assembly Check:
In order to complete the assembly of your new air compressor, a careful inspection should be made to ensure that all of the parts are properly aligned and securely fastened.
1.Inspect air filter to ensure that it is installed and secure.
2.Check oil fill level in crankcase.
9