Model W1775 Nailer/Stapler Kit
OPERATIONS
Loading
When replacing brad nails in your Model W1775, follow these guidelines:
Gauge: 18
Brad Length:
Staple Length:
Capacity: 100
To load your nailer/stapler, do these steps:
1.DISCONNECT NAILER/STAPLER FROM THE AIR SUPPLY!
2.Grip the nailer/stapler firmly, unlatch the catch lever (Figure 3), and pull the magazine pusher back completely.
Figure 3. Catch lever engaged and
magazine pusher retracted.
3.Insert a strip of brads or staples, pointed-end down, into the magazine as shown in Figure 4.
Pusher |
Magazine |
Sight Window |
Figure 4. Loading nails into magazine.
4.Slide the staples or brads all the way down to the nose of the nailer/sta- pler.
5.Push the magazine toward the nose of the nailer/stapler until the catch lever locks.
6.Reload the nailer/stapler when the magazine sight window (Figure 4) shows the nail or staple level is low. The sight window shows up to approxi- mately 50 nails or staples loaded.
Operating
If you have not read the safety instructions in this manual, do not operate the nailer/stapler.
Before you operate your nailer/stapler, place two to three drops of the included oil into the quick connect fitting where the nailer/stapler connects to the air supply, unless using a lubricator unit.
To operate your nailer/stapler, do these steps:
1.Connect the air supply to the quick connect fitting.