Woodstock W1099 VIII. Adjustment Locations, Shows the adjustment locations for the dovetail jig

VIII. ADJUSTMENT LOCATIONS

The W1099 Dovetail Jig has been designed to accommodate various stock thicknesses and router base sizes. Figure 4 shows the locations for all necessary Dovetail Jig adjustments.

When describing adjustments and operations in this manual, reference is made to the pieces being joined as fronts, backs or sides. These pieces indicate drawer fronts, backs, and sides.

Front and back pieces mount horizontally on top of the jig and side pieces mount vertically in the front of the jig. The insides of the boards always face out!

1.	The hand levers clamp your workpiece in	4.	The front side stops align the vertical work-
	place.		piece to the horizontal workpiece.
2.	The fence knobs hold the fence in place.	5.	The template knobs hold the template in
	Loosen these knobs to adjust fence position.		place. Loosen these knobs to adjust template
	Router travel is stopped when the router base		position.
	contacts the fence.

3.The upper side stops align the workpiece horizontally under the template.

6.The clamping pressure knobs control the height of the clamping bar and adjust cam clamping pressure.

Hand Lever

Template Knob

Clamping Pressure Knob

Fence Knob

Upper Side Stops

Front Side Stops

Clamping Pressure Knob

Hand Lever

Figure 4 shows the adjustment locations for the dovetail jig.

- 6 - Woodstock Intl., Inc. W1099