IV. UNPACKING
Remove the items packed in the carton. It may be a good idea to save the carton and packing material in case they might be needed in the future. Upon removal of all items from the package, you should have:
1.Dovetail Jig
2.Hand Levers (2)
3.Manual
Hand Lever
Dovetail Jig
Hand Lever
Figure 1 shows the dovetail jig with handles.
V. ASSEMBLY
A. HAND LEVERS
The jig is shipped fully assembled except for the two hand levers. Screw the threaded end of each hand lever into the clamping rods located on the top and front of the dovetail jig. Tighten until secure. Figure 1.
B.MOUNTING
1.Place the jig on your bench top so the front lap rests against the front of the bench top.
2.Locate the mounting holes in the rear of the jig. Scribe the hole locations and determine whether to use nuts and bolts, or lag screws. Drill the appropriate size holes.
3.Secure the jig to your bench top. Screws can be tightened by inserting a long screwdriver through the unthreaded holes in the back of the jig.
Hint: If you do not wish to permanently devote bench space to the dovetail jig, mount the jig to a piece of 3/4" plywood that can be clamped to your bench top.
- 4 - | Woodstock Intl., Inc. W1099 |