Woodstock W1822 owner manual Pivot handles installed

Model W1822 (For Machines Mfg. Since 9/10)

17.	Remove the T-bolt from the knurled pivot handle
	of the crosscut fence and set it aside for use in the	Forward
	next steps.	Set Screw
18.	Slide the miter gauge bar into the sliding table miter		T-Bolt
	gauge slot, as shown in Figure 13.

19.While holding the crosscut fence in position, rotate it slightly so that you can insert the T-bolt you removed from the handle in Step 17 into the fence slot and into the sliding table miter gauge slot, as shown in Figure 13.

20.Position the fence along the table, then tighten the forward miter gauge bar set screw (see Figure 13) and the miter gauge lock knob (see Figure 14) to secure the fence in place.

21.Use a square to position the fence exactly 90° to the saw blade, then thread and tighten the two knurled pivot handles with a plastic washer onto the fence bolts, as shown in Figure 14.

Note: The handles have different thread sizes and each will only fit a specific bolt.

-11-

Figure 13. Installing the fence T-bolts into

the sliding table miter gauge slots.

Pivot

Handles

Lock Knob

Point Cap Screws

Figure 14. Pivot handles installed.

SETUP