Model W1822 (For Machines Mfg. Since 9/10)
Flip Stop
Use the flip stop to make repetitive cuts of the same dimension.
Slide the flip stop
Lock Lever
Figure 18. Flip stop installed.
OPERATIONS
Crosscutting
The Model W1822 enables you to use your table saw to crosscut large panels, as shown in Figure 19.
To make a crosscut with the sliding table, do these steps:
1.DISCONNECT SAW FROM POWER!
2.Position the crosscut fence to the rear of the sliding table, as illustrated in Figure 19, adjust it to be 90° to the blade, then lock it in place.
Make sure the fence will not contact the blade as the sliding table moves through its entire range of motion.
3.Position the extension table just forward of the crosscut fence to provide maximum table support for the workpiece, then lock it in place.
4.If necessary, pull the extension fence out to give additional vertical support to the workpiece.
5.Mount the workpiece flat on the tables and firmly against the crosscut fence.
6.Turn the saw ON, firmly hold the workpiece on the tables and against the fence, then push the fence and sliding table forward to pass the workpiece all the way through the blade to make the cut.
7.Turn the saw OFF, then remove the workpieces.
Blade
Workpiece
Crosscut
Fence