Woodstock W1668 manual Table Height and Tilt, To adjust the table, do these steps

W1668 131⁄4" Oscillating Drill Press

Table Height and Tilt

ADJUSTMENTS

You can adjust the table height and tilt to accommodate for workpiece height or achieve special drilling/sanding angles. You can also move the table out of the way and use the drill press base as a table for drilling/sanding.

To adjust the table, do these steps:

1.Loosen the table lock lever.

2.Turn the hand crank to raise or lower the table, as shown in Figure 30.

3.Position the table so the opening in the installed table insert is centered to the drill bit or sanding drum.

•If the table is not needed, pivot the table to the back side of the column (Figure 31) so you can support the workpiece on the base (drilling operations only).

4.Tighten the table lock lever.

5.Loosen the table tilt lock bolt.

6.Turn the index pin jam nut clockwise and draw the index pin out of the casting until you can rotate the table to your desired angle, and use the tilt scale to find your desired drilling or sanding angle (see Figure

32).

NOTE: Use this index pin only for indexing the table in the “Zero degree” position.

(To index the table back to the zero posi- tion, turn the table to zero, tap the index pin back into the casting, snug the index pin jam nut, and tighten the table tilt lock bolt.)

7.Tighten the tilt table lock bolt, and double check your angle.

Figure 30. Raise or lower the table.

Figure 31. Table adjusted behind column.

Table Tilt

Lock Bolt

Index Pin and

Index Pin Jam

Nut

Tilt

Scale

Figure 32. Table tilt lock bolt.

-18-