Model D3274 Gravity Feed Spray Gun w/Regulator
CLEANING & LUBRICATION
EYE INJURY! Always wear safety glasses when disassembling the spray gun. The material cup may still be pressurized. Parts may also shoot out of the gun pressure is released from the springs.
Cleaning
Proper cleaning is the best way to ensure
Basic spray gun cleaning:
1.Spray a small amount of solvent through the spray gun.
Note: Check with local laws regarding this practice. If you are spraying on a regular basis, spraying solvents into the air may be illegal. A cabinet style spray gun cleaner may be required.
2.DISCONNECT THE SPRAY GUN FROM AIR!
3.Put on safety glasses and unscrew the cup.
4.Disassemble the gun by unscrewing the fluid control knob by hand, and removing the spring and needle (Figure 9).
Fluid Tip | Filter |
| Cup |
| Fluid Control |
| Knob |
Atomizing | Needle |
Cap | Spring |
Figure 11. Disassembly for cleaning.
5.Unscrew the atomizing cap with your fingers and the fluid tip with the service wrench (Figure 1). The fully disassembled gun should look like
Figure 9.
6.Rinse these parts thoroughly in solvent then dry with compressed air or let air dry.
Note: If the small holes in the atomizing cap become blocked, soak them in clean solvent. If the blockage still exists, clear it with a small needle, taking great care not to enlarge or damage the hole. Damage to the hole will create a disrupted spray pattern.