Specifications, Assembly, Controls | Woodstock D3274 specs

Model D3274 Gravity Feed Spray Gun w/Regulator

Specifications


Operating Air Pressure	30–50 PSI
Maximum Air Pressure		70 PSI
Material Cup Capacity		600 CC
Air Consumption	4.2–7.1CFM
Maximum Fluid Pressure		10 PSI
Cup Material		Plastic
Body Material	Aluminum Alloy
Maximum Pattern Width		250mm
Water-Based Material Compatible		.......Yes
Weight		1.5 lbs.

Assembly

1.Insert the filter into the gun body with the knob pointing outward (see

Figure 2).

Figure 2. Installing filter.

2.Screw the cup onto the top of the body.

3.Attach the regulator to the bottom of the spray gun.

4.Attach the air hose to the spray gun regulator with a 1⁄4" NPT quick con- nect fitting (not included).

5.Attach the spray gun to an air supply regulated between 30 and 50 PSI.

Note: For the best results, use a hose that will be dedicated for spray use only. Do not use a hose that has been used with an in-line oiler or other possible contaminant.

-6-

	Controls
		Material Cup
		Fluid Control
	Atomizing	Pattern Control
	Cap	Pattern Control
	Cap	Regulator Control
		Regulator Control
	Trigger
	Air Flow Control

Figure 3. Controls.

•Fluid Control: Controls the volume of material that travels through the fluid tip by adjusting how far the trigger can be pulled back.

•Pattern Control: Adjusts the spray pattern from a round pattern to a wide fan.

•Air Flow Control: Adjusts the fluid pressure inside the spray gun.

•Atomizing Cap: Adjusts the spray pattern from vertical to horizontal.

•Trigger: Two stage trigger. Stage one only releases compressed air for blowing off the work piece. Stage two sprays material.

•Material Cup: Holds the paint to be sprayed.

•Regulator/Gauge: Regulates inlet air pressure to the spray gun. It can be attached directly to the gun for on- the-spot air adjustments or to the air source.

Note: DO NOT attach the spray gun or regulator control to an unregulated air source that exceeds 120 PSI.