Woodstock W1774 owner manual Clearing Jammed Nails

Page 12

Model W1774 18 Gauge Brad Nailer

Clearing Jammed Nails

A jammed nail must be cleared before using the nailer again.

To clear a jammed nail from the dis- charge area, do these steps:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Depress the magazine latch and pull back the magazine cover until it stops.

3.Remove the nail stick from the magazine.

4.Remove the two cap screws and driver guide cover from the nose assembly (see Figure 5).

��

��

Figure 5. Removing guide cover.

5.The jammed nail should now be visible; remove it with needle nose pliers.

6.Throw the damaged nail away and insert a new nail stick that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!

7.Re-install the guide cover with the two cap screws, push the magazine cover all the way forward, and check the operation of the safety nose mechanism (refer to Page 7 for detailed instructions),

-10-

Image 12

Contents Gauge Brad Nailer Page Safety Safety Instructions for Pneumatic ToolsBefore Operating This Equipment Always USE Safety GLASSES. Also use a face or dust mask Additional Safety for Nailers/Staplers Introduction Woodstock Technical SupportMachine Data Typical filter/lubricator/regulator installation order Compressed Air SystemSetup UnpackingInventory Model W1774 Inventory QtySafety Nose Mechanism To check the safety nose mechanism, do these stepsOperations LoadingOperating To load your nailer, do these stepsExample of nail deflection Clearing Jammed Nails Replacing Pistons Rings To replace a piston, do these stepsCleaning & Lubrication CleaningLubricatingBreakdown W1774 Parts List PART# DescriptionTroubleshooting Page Warranty Registration BOX BELLINGHAM, WA