Model W1774 18 Gauge Brad Nailer
OPERATIONS
Loading
When replacing nails in your Model W1774, follow these guidelines:
Gauge: | 18 |
Length: | |
Capacity: | 100 |
To load your nailer, do these steps:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Depress the magazine latch, as shown in Figure 2.
Figure 2. Releasing magazine latch.
3.Pull the magazine cover back until it stops.
4.Insert a strip of nails, pointed-end down, into the magazine, as shown in Figure 3.
Figure 3. Loading nails into magazine.
5.Slide the nails all the way down to the nose of the nailer.
6.Push the magazine cover forward until the magazine latch locks it in place.
Operating
If you have not read the safety instructions in this manual, do not operate the nailer.
Before you operate your nailer, place five to six drops of quality pneumatic tool oil into the quick connect fitting where the nailer connects to the air supply.
To operate your nailer, do these steps:
1.Connect the air supply to the quick connect fitting.
2.To test for proper nail penetration, hold the nailer perpendicular to the surface of a piece of clean scrap wood that is thick enough for the length of nails you have loaded.