Operating Instructions
Troubleshooting Chart
| Symptom | Possible Cause(s) | Corrective Action |
|
| |
Tool runs slowly or will not | 1. Grit or gum in tool | 1. | Flush the tool with Campbell Hausfeld air tool oil, gum |
|
| |
operate |
|
| solvent, or an equal mixture of SAE 10 motor oil and |
|
| |
|
|
|
| kerosene. If Campbell Hausfeld oil is not used, lubricate |
|
|
|
|
|
| the tool after cleaning |
|
|
|
| 2. No oil in tool | 2. | Lubricate the tool according to the lubrication instructions |
|
|
|
|
|
| in |
|
|
|
| 3. Low air pressure | 3. | Adjust the compressor regulator to tool maximum while |
|
|
|
|
|
| tool is running free |
|
|
|
| 4. Air hose leaks | 4. | Tighten and seal hose fittings if leaks are found |
|
|
|
| 5. Pressure drops | 5. | Be sure air hose is properly sized. Long hoses or tools using |
|
|
|
|
|
| large volumes of air may require a hose with an I.D. of 1/2” |
|
|
|
|
|
| or larger depending on total hose length |
|
|
|
|
|
|
|
|
|
Moisture blowing out of tool | 1. Water in tank | 1. | Drain tank (See air compressor manual). Oil tool and run |
|
| |
|
|
|
| until no water is evident. Oil tool again and trigger gun |
|
|
|
| 2. Water in the air lines/ | 2a. | Install a water separator/filter (PA2121). |
|
|
|
| hoses |
| NOTE: Separators work properly only when air steam is |
|
|
|
|
|
| cool. Locate separator/filter as far as possible from |
|
|
|
|
|
| compressor |
|
|
|
|
| 2b. | Install an air dryer |
|
|
|
|
| 2c. | If the original separator will not separate all the water |
|
|
|
|
|
| from the air, install a Campbell Hausfeld belt air filter |
|
|
|
|
|
| (PA2121) |
|
|
|
|
|
|
|
|
|
Tool will not pull rivet shank | 1. Worn jaws | 1. | Replace jaws |
|
| |
|
| 2. Jaws out of | 2. | Adjust jaws to fit correctly with rivet shank (See Operation |
|
|
|
| adjustment |
| Section in manual) |
|
|
www.chpower.com
3