Alignment (continued)
Aligning Belt To Miter Gauge Slot
The sanding belt is installed at the factory; however, check and make sure the belt is parallel to the miter gauge groove:
1.Use a combination square to check the distance from the miter gauge groove to the belt assembly as shown.
2.If adjustment is required, use a 5/32 inch hex “L” wrench provided with unit to loosen the two flat head socket recess screws on the table.
3.Adjust the bed assembly as needed to make it parallel or same distance to the miter gauge slot.
4.Tighten two screws.
Socket Recess
Adjust BedScrews Assembly
Parallel to Miter Gauge Slot
18