RIDGID EB44241 manual On-Off Switch

10.On-Off Switch

11.Backstop Knob. Loosening knob allows backstop to be pivoted.

12.Dust Collection Port. 2-1/2" opening for wet/dry vac hook-up.

13.Table Insert/Sanding Belt Storage. Holds table insert or sanding belt when not being used.

14.Hex “L” Wrench. Use 3/32" wrench to adjust front table and table insert. Use 5/32" wrench to adjust belt to miter gauge slot.

15.Table Insert. Helps to support work- piece when drum sanding.

On-Off Switch

The On-Off switch has a locking feature.

This Feature Is Intended To Help Pre- vent Unauthorized And Possible Haz- ardous Use By Children And Others.

1.To turn sander “ON” insert key into switch.

NOTE: Key is made of yellow plastic, located in loose parts bag.

2.Insert finger under switch lever and Pull end of switch out.

3.To turn sander “OFF”Push. lever in.

WARNING: Never leave the sander unattended until it has come to a complete stop.

4.To lock switch in “OFF” position, hold

switch “IN” with one handRemove. key with other hand.

WARNING: For your own safety, always lock the switch “OFF” when sander is not in use. Remove key and keep it in a safe place. Also, in the event of a power failure (all of your lights go out) turn switch off, remove the key and store it remote from sander.

CAUTION: Before turning switch on, make sure the belt or drum and sleeve are properly installed.

On-Off

Switch

Yellow

Switch Key

Turning

Sander On

Turning

Sander Off

Remove

Yellow Key

21