OPERATION
APPLICATIONS
You may use this tool for the following purposes:
�Charging 9.6 Volt, 12 Volt, 14.4 Volt, and 18 Volt RIDGID slide batteries
CAUTION:
If at any point during the charging process none of the LEDs are lit, remove the battery pack from the charger to avoid damaging the product. DO NOT insert another battery. Return the charger and battery to your nearest service center for service or replacement.
CHARGING THE BATTERY PACK
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it until the light on front of charger changes from flashing green to continuous green.
NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (operation followed by recharging) for them to become fully charged. This is normal for
TO CHARGE
Charge the battery pack only with the charger provided. � Make sure the power supply is normal household voltage,
120 volts, 60 Hz, AC only.
Connect the charger to a power supply.
Attach the battery pack to the charger by aligning the raised ribs on the battery pack with the grooves in the charger, then slide the battery pack onto the charger.
See Figure 2.
The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
Do not place the charger in an area of extreme heat or cold. It will work best at normal room temperature.
For average charge times, refer to the chart on the following page.
When the batteries become fully charged, unplug the charger from the power supply and remove the battery pack.
CHARGING A HOT BATTERY PACK
When using the tool continuously, the battery pack will become hot. Because the dual port charger is
If the battery pack is above normal temperature range, the red LED will begin flashing and the green LED will be off. When the battery pack cools down to approximately 104°F (40°C), the charger will automatically begin fast charge mode.
CHARGER SHOWN WITH 18 VOLT BATTERY PACK
Fig. 2
NOTE: Refer to CHARGING THE BATTERY PACK for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest repair center for electrical check. For the location of your nearest repair center, please call
CHARGING A COOL BATTERY PACK
If the battery pack is below normal temperature range, the red LED will begin flashing and the green LED will be off. When the battery warms to a temperature of more than 41°F (5°C), the charger will automatically begin fast charge mode.
NOTE: Refer to CHARGING THE BATTERY PACK for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest repair center for electrical check. For the location of your nearest repair center, please call
USE THIS RIDGID BATTERY CHARGER ONLY WITH
THE BATTERY PACKS LISTED BELOW.
Part Number | Voltage | Part Number | Voltage |
|
|
|
|
130252007 | 9.6 | 130254008 | 14.4 |
130252002 | 12 | 130252001 | 18 |
130254001 | 12 | 130252004 | 18 |
130252003 | 14.4 | 130254003 | 18 |
130254002 | 14.4 | 130254007 | 18 |
|
|
|
|
4