How To Wire Your Ceiling Fan

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.

!WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.

outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other side of the outlet box.

!WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

1. Connect the green grounding lead from the hanger ball and the green grounding lead form the hanger bracket (if present) to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation).

3. Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket.

4. Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 10).

GROUND WIRE

BLACK AND BLUE FAN WIRES

5. Secure the ceiling cover in place by sliding

lockwashers over the threaded studs and installing

the two knurled knobs (supplied). (Figure 10). Tighten

the knurled knobs securely until the ceiling cover fits

WIRE

CONNECTORS (3)

GREEN WIRE (GROUND)

FROM FAN

Figure 9

WHITE SUPPLY (NEUTRAL)

WHITE FAN

WIRE

BLACK SUPPLY (HOT)

snugly against the ceiling and the hole in the ceiling

cover is clear of the downrod. Your fan is now wired

to be turned on and off from the fan switch.

CEILING COVER

LOCKWASHERS (2)

NOTE: If you are using an Emerson Light Fixture with your fan, remove the three screws securing the switch cup assembly to the fan, remove the switch cup assembly, and disconnect the connector. Remove the screw plug from the bottom of the switch cup and install the light in accordance with the light kit Owner's Manual.

2.Connect the fan motor white wire to the supply white (neutral) wire using a wire connector (supplied) (Figure 9). Connect the fan motor black wire and blue wire to the supply black (hot) wire using a wire connector (supplied) (Figure 9). Your fan is now wired to be turned on and off from the fan switch. After connections have been made, turn leads upward and carefully push leads into the

THREADED STUD

KNURLED KNOB

Figure 10

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

6. Cut the 3-speed switch pull chain to a desired length (optional). Connect the wood pendant (supplied) to the 3-speed switch pull chain by sliding the wooden pendant (small hole first) onto the pull chain. Attach the chain coupler to the end of the chain and allow the wooden pendant to fall down over the coupling.

Using Your Ceiling Fan

!WARNING

To reduce the risk of fire or electrical shock, do not use this fan with any solid-state speed control device.

1. Restore electrical power to the outlet box by turning the electricity on at the main fuse box.

slide the reversing switch to opposite position, and turn fan on again. The fan blades will turn in the opposite direction and reverse the airflow.

Your fan model is equipped with a 4-position, 3-speed pull chain switch. The operating sequence is as follows:

2. Check the operation of the fan by gently pulling on the pull chain switch.

3. All fans are shipped from the factory with the re- versing switch positioned to circulate air downward. If airflow is desired in opposite direction, turn your fan off and wait for the blades to stop turning, then

THREE-SPEED 1st Pull – High 2nd Pull – Medium 3rd Pull – Low 4th Pull – OFF

SPEED

CONTROL

SWITCH

REVERSIBLE SWITCH