RIDGID R840011 manual To Install Battery Pack, To Remove Battery Pack, Switch Trigger

Page 12

OPERATION

TO INSTALL BATTERY PACK

See Figure 4.

Lock the switch trigger on the drill by placing the direction of rotation (forward/reverse/center lock) selector in center position.

Place battery pack in the drill. Align raised rib on battery pack with the groove inside the drill.

Make sure the latches on each side of the battery pack snap in place and battery pack is secured in the drill before beginning operation.

CAUTION:

When placing battery pack in the tool, be sure raised rib on battery pack aligns with the slide on the bottom of the drill and latches snap into place properly. Improper assembly of the battery pack can cause damage to internal components.

TO REMOVE BATTERY PACK

See Figure 4.

Lock the switch trigger on the drill by placing the direction of rotation selector in center position.

Locate latches on side of battery pack and depress to release battery pack from the drill.

The battery pack will automatically disconnect in direction to be removed when buttons are depressed.

Remove the battery pack from the drill.

WARNING:

Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side.

SWITCH TRIGGER

See Figure 5.

To turn the drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.

VARIABLE SPEED

The variable speed switch trigger delivers higher speed and torque with increased trigger pressure and lower speed with decreased trigger pressure.

NOTE: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function.

DEPRESS LATCHES TO

RELEASE BATTERY PACK

Fig. 4

DIRECTION OF ROTATION SELECTOR (FORWARD/REVERSE/CENTER LOCK)

REVERSE

FORWARD

 

SWITCH TRIGGER

Fig. 5

 

12

Image 12
Contents OPERATOR’S Manual Table of Contents IntroductionGeneral Safety Rules Electrical SafetyPersonal Safety Work AreaSpecific Safety Rules ServiceImportant Safety Instructions Safety Rules for ChargerSymbols Symbol Name DESIGNATION/EXPLANATIONService Symbol Signal MeaningFeatures Product SpecificationsPack Charger BIT StorageAssembly Operation LED Function of Charger RED LED Green LEDTo Install Battery Pack To Remove Battery PackSwitch Trigger Depress Latches to Release Battery PackDirection of Rotation Selector Adjustable Torque Clutch Adjusting TorqueInstalling Bits Lock Tighten RightUsing the Auxiliary Handle Assembly Wrong Auxiliary Handle AssemblyRemoving Bits Drilling Maintenance General MaintenanceBattery Pack Removal Preparation for Recycling BatteriesChuck Removal To Retighten a Loose ChuckMallet Chuck Jaws HEX KEY Keyless Screwdriver Warranty Customer Service Information