OPERATION
WOOD DRILLING�
For maximum performance, use high speed steel bits for wood drilling.�
Select drill mode.�
Begin drilling at a very low speed to prevent the bit from slipping off the starting point. Increase the speed as the drill bit bites into the material.�
When drilling through holes, place a block of wood behind the workpiece to prevent ragged or splintered edges on the back side of the hole.�
METAL DRILLING�
For maximum performance, use high speed steel bits for metal or steel drilling.
Select drill mode.
Begin drilling at a very low speed to prevent the bit from slipping off the starting point.�
Maintain a speed and pressure which allows cutting without overheating the bit. Applying too much pressure will:
•Overheat the drill;
•Wear the bearings;
•Bend or burn bits; and
•Produce
When drilling large holes in metal, start with a small bit, then finish with a larger bit. Also, lubricate the bit with oil to improve drilling action and increase bit life.
MASONRY DRILLING
For maximum performance, use
Turn mode change ring to the hammer drill icon to select hammer mode.�
Apply light pressure and medium speed for best results in brick.�
Apply additional pressure for hard materials such as concrete.�
When drilling holes in tile, practice on a scrap piece to determine the best speed and pressure. Begin drilling at a very low speed to prevent the bit from slipping off the starting point.�
20