RIDGID R5011 manual Drilling, To lock-on

Page 14

OPERATION

LOCK-ON BUTTON

See Figure 12.

This drill is equipped with a lock-on feature, which is con- venient for continuous drilling for extended periods of time.

To lock-on:

Depress the switch trigger.

Push in and hold the lock-on button, located on the side of the handle.

Release the switch trigger.

Release the lock-on button and the drill will continue running.

To release the lock, depress and release the switch trigger.

If the lock-on feature is engaged during use and the drill becomes disconnected from the power supply, disengage the lock-on feature immediately.

WARNING:

Before connecting the drill to a power supply source, always check to be sure it is not in lock-on position (depress and release the switch trigger). Failure to ensure that it is not locked-on could result in accidental starting of the drill resulting in possible serious injury. Do not lock the switch trigger in applications where the drill may need to be suddenly stopped.

DRILLING

See Figure 13

Depress and release the switch trigger to be sure the drill is in the OFF position before connecting it to a power supply.

Check the direction of rotation selector for the correct setting (forward or reverse).

Secure the material to be drilled in a vise or with clamps to keep it from turning as the drill bit rotates.

Plug the drill into power supply. Hold the drill firmly and place the bit at the point to be drilled.

Depress the switch trigger to start the drill.

Move the drill bit into the workpiece, applying only enough pressure to keep the bit cutting. Do not force the drill or apply side pressure to elongate a hole. Let the tool do the work.

WARNING:

Be prepared for binding at bit breakthrough. When these situations occur, the drill has a tendency to grab and kick in the opposite direction and could cause loss of control when breaking through material. If not prepared, this loss of control can result in possible serious injury.

LOCK-ON

BUTTON

SWITCH

Fig. 12

TRIGGER

Fig. 13

14

Image 14
Contents OPERATOR’S Manual Double InsulatedTable of Contents IntroductionElectrical Safety General Safety RulesWork Area Safety Personal SafetySpecific Safety Rules ServiceSymbols Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Double Insulation Cord Length Wire Size A.W.GElectrical Electrical ConnectionChuck FeaturesProduct Specifications Lighted PlugAssembly Installing Auxiliary Handle Assembly Installing the Depth Stop RODApplications Switch TriggerOperation LOCK-ON ButtonTWO-SPEED Gear Shift Knob To Install BitsUsing the Auxiliary Handle Assembly To Remove BitsTo adjust the auxiliary handle assembly Adjusting the Depth Stop RODSelecting Hammer Mode or Drilling Drilling ModeDrilling To lock-onMaintenance Mallet Chuck Jaws HEX KEY Screwdriver Chuck RemovalTo Retighten a Loose Chuck What is Covered Under the 3 Year Limited Service Warranty WarrantyDAY Satisfaction Guarantee Policy HOW to Obtain Service What is not CoveredPage Page Customer Service Information Model No R5011 Serial No