Unpacking and Checking Contents
Tools Needed
Medium Screwdriver
Adjustable Wrench
Phillips Screwdriver
Combination Square
Combination Square Must be True
Draw Light | Straight Edge of |
Line on Board | Board 3/4" Thick |
Along this Edge | This Edge Must be |
Framing | Perfectly Straight |
Square |
|
Should be no Gap or Overlap when Square is Flipped Over in Dotted Position
Unpacking
WARNING: For your own safety, never connect plug to power source outlet until all assembly steps are complete, and you have read and understood the safety and operat- ing instructions.
The Drill Press is shipped complete in one box.
1.Separate all “loose parts” from packing materials and check each item with illustration and “Table of Loose Parts.”
WARNING: To reduce the risk of injury, if any parts are missing, do not attempt to assemble the drill press, plug in the power cord, or turn the switch on until the missing parts are obtained and installed correctly.
2. Remove the protective oil that is applied
to the table and column. Use any ordi- nary household type grease and spot remover.
WARNING: To reduce the risk of fire or toxic reaction, never use gas- oline, naptha or similar highly vola- tile solvents to remove protective oil.
3.Apply a coat of paste wax to the table and column to prevent rust. Wipe all parts thoroughly with a clean dry cloth.
NOTE: Make certain all items are accounted for before discarding any pack- ing material.
10