RIDGID DP15501 manual Key

Page 26

Getting To Know Your Drill Press (continued)

25.Support Lock...Tightening locks table support to column. Always have it locked in place while operating the drill press.

26.Chuck Key...It is a self ejecting chuck key which will “pop” out of the chuck when you let go of it. This action is designed to help prevent throwing of the chuck key from the chuck when power is turned “ON”. Do not use any other key as a substitute, order a new one if damaged or lost.

27.Storage Tray...Conveniently holds drill bits and other accessories.

28. On-Off Switch...Has locking feature. This feature is intended to prevent unauthorized and possible hazardous use by children and others.

Insert key into switch.

NOTE: Key is made of yellow plastic.

Key

To turn drill ON, insert finger under switch lever and pull.

To turn drill OFF, push lever in.

NOTE: In an emergency: If the drill bit binds, stalls, stops or tends to tear the workpiece loose, you can quickly turn the drill off by hitting the switch with the palm of your hand.

26

Image 26

Contents +/225 02/5,//3566 Safety Instructions For Drill Press Table of ContentsBefore Using The Drill Press Reduce the Risk of Dangerous EnvironmentInspect your drill press Thrown WorkpieceThink Safety Plan Your Work This drill press has 12 speeds as listed belowKeep Children Away Dress for safetyReduce the Risk of Accidental Starting Before Leaving The Drill PressGlossary of Terms Motor Specifications and Electrical RequirementsPower Supply and Motor Specifications General Electrical ConnectionsVolt, 60 Hz. Tool Information Properly Prong Plug Grounded Prong Outlet GroundingExtension Cord Gauge Length 25-50 Motor Safety ProtectionWire Sizes Unpacking and Checking Contents Description Qty List of Loose PartsLoose Parts Location and Function of Controls Table Bevel Lock...Locks the table in any position from 0Crank AssemblyAssembly of Base/Column Support Table Lock Support Column Crank Rack Installing The TableInstalling the Storage Tray Head Head Lock Installing the Head10mm Dia. x 12mm Set Screw Head Column Adjustment Pulley Alignment and SpeedTensioning Belt Installing Feed HandlesInstalling the Drill Chuck Support Lock Chuck Sleeve Feed Handle WoodBevel Scale Installing Light BulbAdjusting the Table Square To Head Converting From Right Hand Operation to Left Hand Operation Page Cap Quill Return SpringMm Cap Spring Notch Nut Inner Nut OuterAdjusting Belt Latch Guard Latch Adjusting ScrewsGetting To Know Your Drill Press Spindle Speed in R.P.M Belt Guard Latch...Press button to raise belt guardKey Drilling to a Specific Depth Another Way Depth ScaleRemoving Chuck and Arbor Depth Scale Lock Adjust to Desired DepthLocking Chuck at Desired Depth Drift Key Chuck Sleeve Chuck BodySafety Instructions for Basic Drill Press Operation Jaws Installing DrillsBasic Drill Press Operation Workpiece Drill Press Vise Bolt or Clamp Vise Securely Workpiece Backup MaterialPositioning Table and Workpiece Feeding Tilting TableHole Location Bevel Lock Set Screw Bevel ScaleTroubleshooting MaintenanceWiring Diagram MaintenanceLubricationTroubleshooting Probable Cause Remedy Turn nut counterclockwise toAlways order by Part Number Not by Key Number Repair PartsParts List for Ridgid 15 Drill Press Model No. DP15501 Key DescriptionRepair PartsAlways order by Part Number -- Not by Key Number Description Always order by Part Number Not by Key Number Description Parts List for Rdigid 15 Drill Press Model No. DP15501 Part No. SP6490 Form No. SP6490 Number on hand when callingPlease have your Model Number and Serial