RIDGID R250SFA manual Clearing a Jammed Fastener

Page 16

OPERATION

WARNING:

Disconnect the tool from the air supply before clearing a jammed fastener. Failure to do so could result in serious personal injury.

CLEARING A JAMMED FASTENER

See Figure 11.

If a nail or fastener becomes jammed in the tool, disconnect the air hose and keep the tool pointed away from you while clearing the jam.

nRemove fasteners from the tool.

n�Pull up on the latch and open the jam release.

nInsert a flat blade screwdriver into the driving mechanism and push the driver mechanism back, freeing the fastener jam.

nRemove the bent fastener.

nClose the jam release and latch.

nReconnect the tool to the air supply.

nReinstall fasteners.

JAM

RELEASE

LATCH

Fig. 11

16

Image 16

Contents OPERATOR’S Manual R250SFATable of Contents IntroductionGeneral Safety Rules Personal SafetyService Work AreaSpecific Safety Rules OperationAIR Supply and Connections Loading ToolSymbols Symbol Name DESIGNATION/EXPLANATIONGlossary of Terms Activate operating controlsFeatures Product SpecificationsAdjustable Exhaust Depth of Drive AdjustmentQUICK-CONNECT Swivel Connector Know Your Finish NailerAssembly OperationUnpacking Packing ListAdjusting the Exhaust Preparing the Tool for USEConnecting the Tool to AN AIR Supply Loading the Tool with Nails See Figures 6Single Sequential Actuation Mode Using the Selectable TriggerContact Actuation Mode Drive Depth Adjustment Setting the AIR PressureRemoving Nails from the Tool Clearing a Jammed Fastener Maintenance AccessoriesTroubleshooting Problem Possible Cause SolutionWarranty Customer Service Information