RIDGID BS14002 manual Installing Bevel Scale Indicator, Mounting the SAW Table to SAW Body

ASSEMBLY

MOUNTING BEVEL SCALE TO SAW TABLE

See Figure 23.

nLocate the following items:

2 flat head screws, (M5 x 0.8-15)

2 washers, (M5)

2 hex nuts, (M5 x 0.8)

1 bevel scale

1 saw table

nAlign bevel scale on the inside edge of the saw table with the text facing out. Insert the screws through the table and bevel scale as shown.

nInstall a washer and nut. Tighten

INSTALLING BEVEL SCALE INDICATOR

See Figure 24.

nLocate the following items:

1 scale indicator

1 pan head screw, (M5 x 0.8-6)

nInsert screw through the slot in the scale indicator and into the trunnion support. Tighten.

MOUNTING THE SAW TABLE TO SAW BODY

See Figures 25 - 26.

PAN HEAD

SCREW

POINTER

SAW TABLE

TRUNNION

SUPPORT SAW BLADE

U	L L
P

Fig. 24

THROAT PLATE

nLocate the following items:

1 saw table

2 lock knobs

nTo mount saw table, remove throat plate and pull table pin out from the table. Rotate saw table 90° and guide saw blade through slot in saw table.

n�Rotate saw table back and place table screws into trunnion support. Attach using lock knobs.

WARNING:

Unit is shipped with blade installed. Do not plug in or operate unit unless the blade is adjusted and aligned per section titled “Installing and Adjusting the Blade”. Failure to do so could result in possible serious personal injury.

FLAT HEAT	SAW TABLE
SCREWS

10°	0°
		°
	15°
		30° 45

LOCK KNOBS	TABLE PIN	Fig. 25
		SLOT IN
SAW TABLE		SAW TABLE

TABLE	10°	15	° 30° 45°
		0°

SCREWS

SAW

BLADE

TRUNNION

SUPPORT

10° 0°

15°

30°

45°

HEX NUTS

U	L L
P

LOCK KNOBS

BEVEL SCALE WASHERS Fig. 23 Fig. 26

20